A while back, I shot some bullets that had been loaded backwards in the case. I had read about this trick in a book by old Elmer Keith.

He had found it difficult to find good soft nosed hunting bullets in the late 1930s, and had decided to try pulling some military ball bullets and turning them around so that the open end of the Full Metal Jacketed bullet was towards the front. He hoped that they might open up and work like a soft nosed bullet.

Long story short, he said that they worked out fairly well, until he could find some JSP bullets to load with.

I tried the bullets in a post called Dum-Dum Bullets and the Box O' Truth, and sure enough, they either broke apart or expanded fairly well.

Here are a couple of pictures from that test.

First, the loaded rounds with the bullets backwards.

Then the recovered bullets after hitting several gallons of water.

Another look at the recovered bullet.

But the question remained:

How accurate would these bullets shoot at normal hunting distances?

Could you even hit a deer with such a load?

Well, only one way to find out.

I loaded up some .308 rounds with some military 147 grain Ball bullets.

Same cases, same primer, same powder and load.

Only some with the bullet forward, and some with the bullet backwards.

I will shoot them through my Accuracy International AE, to get the best groups that I can.

It is a very accurate rifle, but any rifle is only as good as the bullets you send down the bore.

Before we start, a word about these bullets…

I am shooting some military Ball 147 grain bullets. These are not tack drivers, but they are what Elmer was shooting and I will use them.

They are not going to go into the same hole, either forward or backwards, but we will see what happens.